Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration
Huawei Technologies Proprietary
2-13
Table 2-14 enter cluster view
Operation Command
enter cluster view.
cluster
2.4.4 Configure Cluster IP Address Pool
Before setting up a cluster, you are supposed to configure a private IP address pool.
When a Candidate device is added, the administrator device will dynamically assign a
private IP address, which can be used for communication inside the cluster. In this way,
you can use the administrator device to manage and maintain the member devices.
Perform the following configuration in cluster view.
Table 2-15 Configure cluster IP address pool
Operation Command
Configure cluster IP address pool.
ip-pool administrator-ip-address { ip-mask
| ip-mask-length}
Restore the default IP address pool of
the cluster.
undo ip-pool
Before setting up a cluster, the user should configure a private IP address pool for the
member devices of the cluster.
Note that, the above configuration can only be performed on administrator device, and
must be configured before the cluster is build. The IP address pool of an existing
cluster cannot be modified.
2.4.5 Name Administrator device and Cluster
Every cluster has a name.
Perform the following configuration in cluster view.
Table 2-16 Name the administrator device and cluster.
Operation Command
Name Administrator device and Cluster.
build name
Remove all the member devices from the cluster and
configure the administrator device as a Candidate device.
undo build
This command can only be used on an administrator device. When executed on an
administrator device to configure a different cluster name, the command can be used to
rename the cluster.
To Next Page
Loading...
