Huawei Quidway S3500 Series User Manual

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 3 GARP/GVRP Configuration
Huawei Technologies Proprietary
3-3
Operation Command
Restore the default GARP Hold timer,
Join timer and Leave timer settings
undo garp timer { hold | join | leave }
Restore the default GARP LeaveAll
timer settings.
undo garp timer leaveall
Note that, the value of Join timer should be no less than the doubled value of Hold timer,
and the value of Leave timer should be greater than the doubled value of Join timer and
smaller than the Leaveall timer value. Otherwise, the system will prompt message of
error.
By default, Hold timer is 10 centiseconds, Join timer is 20 centiseconds, Leave timer is
60 centiseconds, and LeaveAll timer is 1000 centiseconds.
3.1.3 Display and Debug GARP
After the above configuration, execute display command in any view to display the
running of GARP configuration, and to verify the effect of the configuration. Execute
reset command in user view to reset the configuration of GARP. Execute debugging
command in user view to debug the configuration of GARP.
Table 3-2 Display and debug GARP
Operation Command
Display GARP statistics
information
display garp statistics [ interface
interface-list ]
Display GARP timer display garp timer [ interface interface-list ]
Clear GARP statistics information reset garp statistics [ interface interface-list ]
Enable GARP event debugging
debugging garp event
Disable GARP event debugging
undo debugging garp event
3.2 Configure GVRP
3.2.1 GVRP Overview
GARP VLAN Registration Protocol (GVRP) is a GARP application. Based on GARP
operating mechanism, GVRP provides maintenance of the dynamic VLAN registration
information in the switch and propagates the information to other switches. All the
GVRP-supporting switches can receive VLAN registration information from other

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English