Operation Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration
Huawei Technologies Proprietary
1-2
(auto-negotiation).They can auto-negotiate and auto-select the optimal operating
mode and speed with the peers, thereby streamlining the system configuration
and management.
z 100Base-FX single-mode/multi-mode Ethernet port operates in 100M full duplex
mode. The duplex mode can be configured as full (full duplex) or auto
(auto-negotiation), and the speed can be set to 100 (100Mbps) and auto
(auto-negotiation).
z For Gigabit Ethernet port, the duplex mode can be configured as full (full duplex)
or auto (auto-negotiation), and the speed can be set to 1000 (1000Mbps) and
auto (auto-negotiation). For Gigabit Ethernet port of
S3552G/S3552P/S3528G/S3528P/S3552F, the duplex mode can be configured
as full (full duplex) or auto (auto-negotiation) or half (half duplex), and the speed
can only be set to 1000 (1000Mbps), which need not configuring. 1000Base-T
Ethernet ports of S3526E/S3526C Ethernet switches can operate in 1000M
full-duplex, 100M half-duplex/ full-duplex, and 10M half-duplex/full-duplex modes.
The configurations of these Ethernet ports are basically the same, which will be
described in the following sections.
1.2 Ethernet Port Configuration
Ethernet port configuration includes:
z Enter Ethernet port view
z Enable/Disable Ethernet port
z Set description character string for Ethernet port
z Set duplex attribute for Ethernet port
z Set speed for Ethernet port
z Set cable type for the Ethernet port
z Enable/Disable flow control for Ethernet port
z Set Ethernet port broadcast suppression ratio
z Set link type for Ethernet port
z Add the Ethernet port to specified VLANs
z Set the default VLAN ID for the Ethernet port
z Set the VLAN VPN Feature (S3552G/S3552P/S3528G/ S3528P/S3552F Ethernet
Switches support)
z Set loopback detection for the Ethernet port (S3526/S3526 FS/S3526 FM/
S3526E/S3526C Ethernet Switches support)
z Set the time interval of calculating port statistics information
1.2.1 Enter Ethernet port view
Before configuring the Ethernet port, enter Ethernet port view first.
Perform the following configuration in system view.
To Next Page
Loading...
Need help?
General
