Huawei Quidway S3500 Series User Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-15
The configuration on the loghost must be the same with that on the switch. For related
configuration, see the configuration examples in the later part.
4.5.4 Sending the Configuration Information to Console terminal
To send configuration information to console terminal, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-24 Enable/disable info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
 Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to console terminal
Perform the following operation in system view.
Table 4-25 Configuring to output information to console terminal
Operation Command
Output information to Console
info-center console
channel{ channel-number | channel-name }
Cancel the configuration of
outputting information to Console
undo info-center console channel
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following operation in system view:

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English