Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration
Huawei Technologies Proprietary
2-10
Table 2-9 Set delay for collected device to forward topology collection request.
Operation Command
Set delay for collected device to forward
topology collection request.
ntdp timer hop-delay time
Restore the default delay for collected device
to forward topology collection request.
undo ntdp timer hop-delay
Set delay for collected port to forward
topology collection request.
ntdp timer port-delay time
Restore the default delay for collected port to
forward topology collection request.
undo ntdp timer port-delay
By default, the device to be collected forwards the topology request after delaying for
200ms, the port to be collected forwards the topology collection request after a delay of
20ms.
2.3.6 Set Topology Collection Interval
In order to learn the global topology changes in time, it is necessary to periodically
collect the topology information throughout the whole scope specified.
Perform the following configuration in system view.
Table 2-10 Set topology collection interval
Operation Command
Set topology collection interval
ntdp timer interval-in-mins
Restore the default topology collection interval.
undo ntdp timer
By default, the value of topology collection is 0, that is, the regular topology collection
will not be performed.
2.3.7 Start manually Topology Information Collection
After the topology collection interval is specified, NTDP will automatically and
periodically collects topology information throughout the network. Besides, NTDP also
provides commands for network topology collection manually.
Whenever you want to manually collect the network topology information for the
purpose of device management and monitoring, simply use the following command to
start the process.
Perform the following configuration in user view.
To Next Page
Loading...
Need help?
General
