Huawei Quidway S3500 Series User Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-24
Table 4-41 Configuring the output format of time-stamp
Operation Command
Configure the output format of
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }
4.5.8 Sending the Configuration Information to SNMP Network Management
To send configuration information to SNMP NM, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-42 Enabling/disabling info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
 Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to SNMP NM
Perform the following operation in system view.
Table 4-43 Configuring to output information to SNMP NM
Operation Command
Output information to SNMP NM
info-center snmp channel
{ channel-number | channel-name }
Cancel the configuration of
outputting information to SNMP NM
undo info-center snmp channel
3) Configuring information source on the switch
By this configuration, you can define the information that sent to SNMP NM is
generated by which modules, information type, information level, and so on.

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English