Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 7 BOOTP Client Configuration
Huawei Technologies Proprietary
7-2
Table 7-1 Configuring a VLAN interface to obtain the IP address using BOOTP
Operation Command
Configure VLAN interface to obtain IP
address using BOOTP
ip address bootp-alloc
Remove the configuration
undo ip address bootp-alloc
By default, the VLAN interface cannot use BOOTP to get IP address.
7.3 Displaying and Debugging BOOTP Client
After the above configuration, execute display command in any view to display the
running of the BOOTP client configuration, and to verify the effect of the configuration.
Execute debugging command in user view to debug BOOTP client.
Table 7-2 Displaying and debugging BOOTP client
Operation Command
Display information of BOOTP client
display bootp client [ interface
vlan-interface vlan_id ]
Disable/enable BOOTP client debugging
[ undo ] debugging bootp client
To Next Page
Loading...
