Huawei Quidway S3500 Series User Manual

Operation Manual - Auto Detecting
Quidway S3500 Series Ethernet Switches Chapter 1 Configuring Auto Detecting
Huawei Technologies Proprietary
1-1
Chapter 1 Configuring Auto Detecting
 Note:
Quidway S3552F /S3552G /S3552P /3528G /3528P /S3526E /S3526E FM /S3526E
FS /S3526C Ethernet Switches support the Auto Detecting feature.
1.1 Introduction to Auto Detecting
Auto detect is a function that detects the connectivity of a network regularly using ICMP
request/rely packets.
Auto detect is carried out through detecting groups, which contain IP addresses of
interfaces to be detected. You can examine the connectivity of a network by checking
the results of detecting groups, which in turn enables you to locate network problems in
time and take proper measures.
1.1.1 Configuring Auto Detect
Table 1-1 Configure auto detect
Operation Command Remarks
Enter system view <Quidway> system-view –
Create a detecting
group and enter its view
[Quidway] detect-group group-number Required
Configure an IP
address of the interface
to be detected in the
detecting group
[Quidway-detect-group-X] detect-list
lis-number ip address ip-address
[ nexthop ip-address ]
Required
Specify how the
detecting result is
generated
[Quidway-detect-group-X] option [ and
| or ]
Optional.
Defaults to
and.
Specify the detecting
interval
[Quidway-detect-group-X] timer loop
seconds
Optional.
Defaults to 15
seconds.
Specify the maximum
retries during a
detection
[Quidway-detect-group-X] retry
retry-times
Optional.
Defaults to 2.

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English