Operation Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Configuration
Huawei Technologies Proprietary
2-14
Table 2-17 Configuring port traffic limit
Operation Command
Configure the port traffic limit
line-rate target-rate
Cancel the configuration port traffic limit
undo line-rate
Ethernet Switch supports the function of configuring configure a traffic limit for a single
port.
For details about the command, refer to the Command Manual.
2.3.5 Configuring Packet Redirection
Packet redirection is to redirect the packets to be forwarded to CPU or other output
port.
You can use the following command to configure the packet redirection.
Perform the following configuration in system view.
Table 2-18 Configuring redirection
Operation Command
Configure
redirection
traffic-redirect { user-group { acl-number | acl-name } [ rule
rule ] | { ip-group { acl-number | acl-name } [ rule rule ] |
link-group { acl-number | acl-name } [ rule rule ] }* } { cpu |
{ interface interface-name | interface-type interface-num } }
Cancel the
redirection
configuration
undo traffic-redirect { user-group { acl-number | acl-name }
[ rule rule ] | { ip-group { acl-number | acl-name } [ rule rule ] |
link-group { acl-number | acl-name } [ rule rule ] }* }
Note that the packets redirected to the CPU will not be dealt.
 Note:
The configuration of redirection only takes effects on the rules with action permit.
For details about the command, refer to the Command Manual.
2.3.6 Configuring Priority Marking
The priority marking configuration is a policy to tag the priority for the packets matching
the ACL. The new priority can be filled in the priority field of the packet header.
You can use the following command to configure the priority marking.
To Next Page
Loading...
Need help?
General
