Operation Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Region-configuration
Huawei Technologies Proprietary
1-21
You can configure the port priority in the following ways.
I. Configure in system view
Perform the following configuration in system view.
Table 1-16 Configure the port priority
Operation Command
Configure the port
priority.
stp interface interface-list instance instance-id port
priority priority
Restore the default port
priority.
undo stp interface interface-list instance instance-id
port priority
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-17 Configure the port priority
Operation Command
Configure the port priority.
stp [ instance instance-id ] port priority
priority
Restore the default port priority. undo stp [ instance instance-id ] port priority
You can configure the port priority with either of the above-mentioned measures. For
more about the commands, refer to the Command Manual.
Upon the change of port priority, MSTP will recalculate the port role and transit the state.
Generally, a smaller value represents a higher priority. If all the Ethernet ports of a
switch are configured with the same priority value, the priorities of the ports will be
differentiated by the index number. The change of Ethernet port priority will lead to
spanning tree recalculation. You can configure the port priority per actual networking
requirements.
By default, the priority of all the Ethernet ports is 128.
1.2.12 Configure the Port (not) to Connect with the Point-to-Point Link
The point-to-point link directly connects two switches.
You can configure the port (not) to connect with the point-to-point link in the following
ways.
I. Configure in system view
Perform the following configuration in system view.
To Next Page
Loading...
Need help?
General
