Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-23
of this group of lists, it means that the routing information has been filtered by this group
of as-path lists identified with this list number.
III. Defining route-policy
Refer to the “Define a route-policy” part of the “IP Routing Policy Configuration”.
IV. Defining match principle
Refer to the “Define if-match clauses for a Route-policy” part in the “IP Routing Policy
Configuration”.
V. Defining evaluation rules
Refer to the “Define apply clauses for a Route-policy” part in the “IP Routing Policy
Configuration”.
5.2.18 Clearing BGP Connection
After the user changes BGP policy or protocol configuration, they must cut off the
current connection so as to enable the new configuration.
Perform the following configuration in user view.
Table 5-39 Clearing BGP connection
Operation Command
Clear the connection between BGP
and the specified peers
reset bgp peer-address [ flap-info ]
Clear all connections of BGP
reset bgp all
Clear the connections between the
BGP and all the members of a group
reset bgp group group-name
5.2.19 Refreshing BGP Routes
When BGP routing policy changes, it is required to re-compute associated route
information.
Please perform the following configuration in user view.
Table 5-40 Refreshing BGP routes
Operation Command
Refreshing general BGP
routes
refresh bgp { all | peer-address | group
group-name } [ import ]
To Next Page
Loading...
Need help?
General
