Operation Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA and RADIUS Protocol Configuration
Huawei Technologies Proprietary
3-17
Note:
The main attributes of the Accounting-On message –– NAS-ID, NAS-IP and session ID
are often generated automatically by the switch. However, you can configure the
NAS-IP using the nas-ip command. Make sure you set a correct and valid NAS-IP
address. Otherwise, the switch automatically selects the IP address of the virtual VLAN
interface as NAS-IP.
II. Configuration preparations
Create the RADIUS scheme and configure the RADIUS authentication/accounting
server in the scheme as CAMS.
III. Configuration tasks
The following table describes the user Re-authentication at reboot configuration tasks.
Table 3-20 User Re-authentication at reboot configuration
Item Command Description
Enter system view
system-view
––
Enter RADIUS scheme view
radius scheme
radius-scheme-name
––
Enable user re-authentication
at reboot
accounting-on enable
[ send times ] [ interval
interval ]
By default, this feature
is not enabled.
3.3.12 Setting the Supported Type of RADIUS Server
Quidway Series Switches support the standard RADIUS protocol and the extended
RADIUS service platforms, such as IP Hotel, 201+ and Portal, independently
developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS scheme view.
Table 3-21 Setting the supported type of RADIUS server
Operation Command
Setting the Supported Type of
RADIUS Server
server-type { huawei | iphotel | portal |
standard }
Restore the Supported Type of
RADIUS Server to the default setting
undo server-type
To Next Page
Loading...
