Huawei Quidway S3500 Series - Section 5

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Table of Contents
Huawei Technologies Proprietary
i
Table of Contents
Chapter 1 IP Routing Protocol Overview.................................................................................... 1-1
1.1 Introduction to IP Route and Routing Table ...................................................................... 1-1
1.1.1 IP Route and Route Segment ................................................................................. 1-1
1.1.2 Route Selection through the Routing Table............................................................ 1-2
1.2 Routing Management Policy.............................................................................................. 1-4
1.2.1 Routing protocols and the preferences of the corresponding routes...................... 1-4
1.2.2 Supporting Load Sharing and Route Backup.......................................................... 1-5
1.2.3 Routes Shared between Routing Protocols............................................................ 1-6
Chapter 2 Static Route Configuration......................................................................................... 2-1
2.1 Introduction to Static Route ...............................................................................................2-1
2.1.1 Attributes and Functions of Static Route................................................................. 2-1
2.1.2 Default Route .......................................................................................................... 2-1
2.2 Static Route Configuration................................................................................................. 2-2
2.2.1 Configuring a Static Route ...................................................................................... 2-2
2.2.2 Configuring a Default Route.................................................................................... 2-3
2.2.3 Configuring the Default Preference Of Static Routes ............................................. 2-3
2.3 Displaying and Debugging Static Route............................................................................ 2-4
2.4 Typical Static Route Configuration Example ..................................................................... 2-4
2.5 Static Route Fault Diagnosis and Troubleshooting ........................................................... 2-5
Chapter 3 RIP Configuration ........................................................................................................ 3-1
3.1 Brief Introduction to RIP..................................................................................................... 3-1
3.2 RIP Configuration............................................................................................................... 3-2
3.2.1 Enabling RIP and Entering RIP view....................................................................... 3-2
3.2.2 Enabling RIP on Specified network......................................................................... 3-3
3.2.3 Configuring Unicast of the Message ....................................................................... 3-3
3.2.4 Specifying RIP Version of the Interface .................................................................. 3-4
3.2.5 Configuring RIP-1 zero field check of the interface packet..................................... 3-4
3.2.6 Specifying the operating state of the interface........................................................ 3-5
3.2.7 Disabling host route ................................................................................................ 3-6
3.2.8 RIP-2 Route Aggregation Function......................................................................... 3-6
3.2.9 Setting RIP-2 Packet Authentication....................................................................... 3-6
3.2.10 Configuring Split Horizon ...................................................................................... 3-7
3.2.11 Configuring RIP to Import Routes of Other Protocols........................................... 3-7
3.2.12 Configuring Default Cost for the Imported Route.................................................. 3-8
3.2.13 Setting the RIP Preference ................................................................................... 3-8
3.2.14 Setting Additional Routing Metric.......................................................................... 3-9
3.2.15 Configuring Route Filtering ................................................................................... 3-9