Huawei Quidway S3500 Series User Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 1 Stack Function Configuration
Huawei Technologies Proprietary
1-2
Table 1-1 Configure IP address pool for the stack
Operation Command
Configure IP address range
for a stack
stacking ip-pool from-ip-address
ip-address-number [ ip-mask ]
Restore to the default IP
address range
undo stacking ip-pool
Before setting up a stack, the user should configure a public IP address pool for the
slave switch of the stack.
Please note that the above configurations can only be performed on the non-stack
switches. After a stack is enabled, the user is prevented from modifying the IP address
pool.
1.2.2 Enable/Disable a Stack
When the user enables a stack with the following command, the system will
automatically add the switches, connected to the main switch via stack ports, to the
stack. After a stack has been enabled, if the stack port is disconnected, slave switch will
exit the stack automatically.
Perform the following configuration in system view.
Table 1-2 Enable/Disable a stack
Operation Command
Enable a stack
stacking enable
Disable a stack
undo stacking enable
Please note that you can only operate on the main switch to disable a stack.
1.2.3 Switch to a Slave Switch view to Perform the Configuration
The following command can be used to switch from the main switch view to a slave
switch view to change the configuration.
Please perform the following configurations in user view.
Table 1-3 Switch to a slave switch view to perform the configuration
Operation Command
Switch to a slave switch view to
perform the configuration
stacking num

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English