Huawei Quidway S3500 Series User Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA and RADIUS Protocol Configuration
Huawei Technologies Proprietary
3-5
Table 3-2 Configuring relevant attributes of ISP domain
Operation Command
Specify the adopted RADIUS scheme
radius-scheme radius-scheme-name
Restore the adopted RADIUS scheme to
the default RADIUS scheme
undo radius-scheme
Specify the ISP domain state to be used state { active | block }
Set a limit to the amount of supplicants
access-limit { disable | enable
max-user-number }
Restore the limit to the default setting
undo access-limit
Set the idle
idle-cut { disable | enable minute
flow }
By default, after an ISP domain is created, the used RADIUS scheme is the default one
named “system” (for relevant parameter configuration, refer to the Configuring RADIUS
section of this chapter).,the state of domain is active , there is no limit to the amount of
supplicants ,and the idle-cut function is disabled.
3.2.3 Creating a Local User
A local user is a group of users set on NAS. The username is the unique identifier of a
user. A supplicant requesting network service may use local authentication only if its
corresponding local user has been added onto NAS.
Perform the following configurations in system view
Table 3-3 Creating/Deleting a local user and relevant properties
Operation Command
Add local users
local-user user-name
Delete all the local users
undo local-user all
Delete a local user by specifying its type
(S3526, S3526 FM and S3526 FS
switches don’t support ssh parameter.)
undo local-user { user-name | all
[ service-type { lan-access | ftp |
telnet | ssh } ] }
By default, there is no local user in the system.
3.2.4 Setting Attributes of Local User
The attributes of a local user include its password display mode, state, service type and
some other settings.

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English