Huawei Quidway S3500 Series User Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-12
Table 4-18 Sending the configuration information to SNMP
Device Configuration Default value Configuration description
Enable info-center
By default,
info-center is
enabled.
Other configurations are
valid only if the info-center is
enabled.
Set the information
output direction to
SNMP
- -
Set information
source
-
You can define which
modules and information to
be sent out and the
time-stamp format of
information, and so on. You
must turn on the switch of the
corresponding module
before defining output
debugging information.
Switch
Configuring SNMP
features
-
See Chapter 5 SNMP
Configuration
Network
managemen
t workstation
The same as the
SNMP
configuration of the
switch
- -
7) Turn on/off the information synchronization switch in Fabric
Table 4-19 Turn on/off the information synchronization switch in Fabric
Device Configuration Default value Configuration description
Enable
info-center
By default, info-center
is enabled.
Other configurations are
valid only if the info-center
is enabled.
Switch
Set the
information
output direction
to SNMP
By default, switches of
master log in Fabric,
debugging and trap
information
synchronization are
turned on, so as log
and strap information
synchronization
switches in other
switches.
This configuration can keep
log information, debugging
information and trap
information in Fabric in
every switch synchronized.
4.5.3 Sending the Configuration Information to Loghost
To send configuration information to loghost, follow the steps below:

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English