Huawei Quidway S3500 Series - Page 588

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-11
4) Sending the configuration information to log buffer.
Table 4-16 Sending the configuration information to log buffer
Device Configuration Default value Configuration description
Enable info-center
By default,
info-center is
enabled.
Other configurations are
valid only if the info-center is
enabled.
Set the information
output direction to
logbuffer
-
You can configure the size of
the log buffer at the same
time.
Switch
Set information source -
You can define which
modules and information to
be sent out and the
time-stamp format of
information, and so on. You
must turn on the switch of the
corresponding module
before defining output
debugging information.
5) Sending the configuration information to trap buffer.
Table 4-17 Sending the configuration information to trap buffer
Device Configuration Default value Configuration description
Enable info-center
By default,
info-center is
enabled.
Other configurations are
valid only if the info-center is
enabled.
Set the information
output direction to
trapbuffer
-
You can configure the size of
the trap buffer at the same
time.
Switch
Set information source -
You can define which
modules and information to
be sent out and the
time-stamp format of
information, and so on. You
must turn on the switch of the
corresponding module
before defining output
debugging information.
6) Sending the configuration information to SNMP