Huawei Quidway S3500 Series User Manual

Operation Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 3 Logon User ACL Control Configuration
Huawei Technologies Proprietary
3-2
Table 3-1 Defining the basic ACL
Operation Command
Enter basic ACL view(from system
view)
acl { number acl-number | name
acl-name basic } [ match-order
{ config | auto } ]
add a sub-item to the ACL(from basic
ACL view)
rule [ rule-id ] { permit | deny } [ source
source-addr wildcard | any ] [ fragment ]
[ time-range name ]
delete a sub-item from the ACL(from
basic ACL view)
undo rule rule-id [ source ] [ fragment ]
[ time-range ]
Delete one ACL or all the ACL(from
system view)
undo acl { number acl-number | name
acl-name | all }
In the defining process, you can configure several rules for an ACL, using the rule
command repeatedly.
3.2.2 Calling ACL to Control TELNET Users
To control TELNET users with ACL, you can call the defined ACL in user-interface view.
You can use the following command to call an ACL.
Perform the following configuration in corresponding view.
Table 3-2 Calling ACL to control TELNET users
Operation Command
Enter user-interface view(from system
view)
user-interface [ type ] first-number
[ last-number ]
Call an ACL(from user-interface view) acl acl-number { inbound | outbound }
For detailed description of the command, refer to the Command Manual.
 Note:
Only the numbered basic ACL can be called for TELNET user control.
3.2.3 Configuration Example
I. Networking requirements
Only permit TELNET user from 10.110.100.52 and 10.110.100.46 access switch.

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English