Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 7 NTP Configuration
Huawei Technologies Proprietary
7-10
Table 7-14 Set the maximum local dynamic sessions
Operation Command
Set the maximum local dynamic
sessions
ntp-service max-dynamic-sessions
number
Restore the default value of the
maximum number of local dynamic
sessions
undo ntp-service max-dynamic-sessions
By the default, the number of local dynamic sessions is 100.
7.3 NTP Display and Debugging
After completing the above configurations, you can use the display command to show
how NTP runs and verify the configurations according to the outputs.
In user view, you can use the debugging command to debug NTP.
Table 7-15 NTP display and debugging
Operation Command
Display the status of NTP service
display ntp-service status
Display the status of sessions maintained by
NTP service
display ntp-service sessions
[ verbose ]
Display the brief information about every NTP
time server on the way from the local
equipment to the reference clock source.
display ntp-service trace
Enable NTP debugging
debugging ntp-service
7.4 Typical NTP Configuration Example
I. Configure NTP server
1) Network requirements
On Quidway1, set local clock as the NTP master clock at stratum 2. On Quidway2,
configure Quidway1 as the time server in server mode and set the local equipment as
in client mode.
2) Networking diagram
To Next Page
Loading...
