Huawei Quidway S3500 Series - Configuring HABP Client; Displaying and Debugging HABP Attribute

Operation Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 5 HABP Configuration
Huawei Technologies Proprietary
5-2
Table 5-1 Configuring HABP server
Operation Command
Enable HABP attribute
habp enable
Restore HABP attribute to the default value
undo habp enable
Configure the switch as HABP Server
habp server vlan vlan-id
Delete HABP Server configuration
undo habp server
Set time interval for HABP request transmission
habp timer interval
Restore the time interval to the default value
undo habp timer
By default, HABP attribute is disabled at a switch, the HABP mode is client, and the
time interval for HABP request transmission is 20 seconds.
5.2.2 Configuring HABP Client
HABP client runs at the member switches. Since the default HABP mode is client, you
only need to enable HABP attribute at a switch.
Please perform the following operations in system view.
Table 5-2 Configuring HABP client
Operation Command
Enable HABP attribute
habp enable
Restore HABP to the default value
undo habp enable
By default, HABP attribute is disabled at a switch.
5.3 Displaying and Debugging HABP Attribute
After the above configurations, you can view HABP attribute information using the
display command in any view, or just for check. You can also debug HABP module
using the debugging command in user view.
Table 5-3 Displaying and debugging HABP attribute
Operation Command
Display configuration information and state of
HABP attribute
display habp
Display MAC address table of HABP attribute
display habp table
Display HABP packet statistics
display habp traffic
Display HABP debugging state
display debugging habp