Huawei Quidway S3500 Series User Manual

Operation Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Region-configuration
Huawei Technologies Proprietary
1-27
II. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1-25 Enable/Disable MSTP on a port
Operation Command
Enable MSTP on a port.
stp enable
Disable MSTP on a port.
stp disable
You can enable/disable MSTP on a port with either of the above-mentioned measures.
For more about the commands, refer to the Command Manual.
Note that redundant route may be generated after MSTP is disabled.
By default, MSTP is enabled on all the ports after it is enabled on the device.
1.3 Display and Debug MSTP
After the above configuration, execute display command in any view to display the
running of the MSTP configuration, and to verify the effect of the configuration. Execute
reset command in user view to clear the statistics of MSTP module. Execute
debugging command in user view to debug the MSTP module
Table 1-26 Display and Debug MSTP
Operation Command
Show the configuration
information about the current
port and the switch.
display stp instance instance-id [ interface
interface-list [ brief ]
Show the configuration
information about the region.
display stp region-configuration
Clear the MSTP statistics
information.
reset stp [ interface interface-list ]
Enable/Disable MSTP (packet
receiving/transmitting, event,
error) debugging on the port.
[ undo ] debugging stp [ interface
interface-list ] { packet | event }
Enable/Disable the global MSTP
debugging.
[ undo ] debugging stp { global-event |
global-error | all }
Enable/Disable specified STI
debugging
[ undo ] debugging stp instance instance-id

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English