Huawei Quidway S3500 Series - Portal Authentication-Free User and Free IP Address Configurations; Portal Authentication-Free User and Free IP Address Configuration Tasks

Operation Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 2 Portal Configuration
Huawei Technologies Proprietary
2-11
# Configure authentication network segments.
[Quidway] portal auth-network 162.31.0.0 255.255.0.0 vlan 100
# Configure Portal operating mode as Layer 3 Portal authentication.
[Quidway] portal method layer3
# Configure VLAN 100.
[Quidway] vlan 100
[Quidway-vlan100] port ethernet 0/6
[Quidway-vlan100] quit
[Quidway] interface vlan-interface 100
[Quidway-Vlan-interface100] ip address 162.21.1.1 255.255.0.0
# Enable Portal authentication on VLAN interface 100. The Portal server name is newp.
For its configuration, refer to section 2.2.3 “Portal Direct Authentication Configuration
Example”.
[Quidway-Vlan-interface100] portal newp
2.3 Portal Authentication-Free User and Free IP address
Configurations
 Note:
Before configuring Portal authentication-free users and free IP addresses, you must
complete Portal configuration tasks.
2.3.1 Portal Authentication-Free User and Free IP Address Configuration
Tasks
The following table describes Portal authentication-free user and free IP address
configuration tasks. These configurations are optional.
Table 2-2 Portal configuration
Steps Command Description
Enter the system view
system-view
—
Configure free IP
addresses
portal free-ip ip-address
You can configure up to
eight free IP addresses.
The Portal server uses a
free IP address
automatically.