Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 2 MAC Address Table Management
Huawei Technologies Proprietary
2-4
2.3 Displaying and Debugging the MAC Address Table
After the above configuration, execute display command in any view to display the
running of the MAC address table configuration, and to verify the effect of the
configuration.
Execute debugging command in user view to debug MAC address table configuration.
Table 2-4 Displaying and debugging the MAC address table
Operation Command
Display the information in the address
table
display mac-address [ mac-addr
[ vlan vlan-id ] | [ static | dynamic ]
[ interface { interface-name |
interface-type interface-num } ] [ vlan
vlan-id ] [ count ] ]
Display the aging time of dynamic
address table entries
display mac-address aging-time
Enable the address table management
debugging
debugging mac-address
Disable the address table management
debugging
undo debugging mac-address
2.4 MAC Address Table Management Configuration Example
I. Networking requirements
The user logs in the switch via the Console port to configure the address table
management. It is required to set the address aging time to 500s and add a static
address 00e0-fc35-dc71 to Ethernet 0/2 in vlan1.