Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-26
4) Configuring of SNMP and network management workstation on the switch
You have to configure SNMP on the switch and the remote workstation to ensure that
the information is correctly sent to SNMP NM. Then you can get correct information
from network management workstation. SNMP configuration on switch refers to
Chapter 5 SNMP Configuration.
4.5.9 Turn on/off the Information Synchronization Switch in Fabric
After the forming of a Fabric by switches which support the XRN, the log, debugging
and trap information among the switches is synchronous. The synchronization process
is as follows: each switch sends its own information to other switches in the Fabric and
meantime receives the information from others, and then the switch updates the local
information to ensure the information coincidence within the Fabric.
The switch provides command line to turn on/off the synchronization switch in every
switch. If the synchronization switch of a switch is turned off, it does not send
information to other switches but still receives information from others.
1) Enable info-center
Perform the following operation in system view.
Table 4-46 Enable/disable info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
2) Turn on the information synchronization switch
Perform the following operation in system view.
Table 4-47 Turn on/off the information synchronization switch of every switch
Operation Command
Turn on the information synchronization
switch of the specified switch
info-center switch-on { unit-id | master
| all } [ debugging | logging |
trapping ]*
Turn off the information synchronization
switch of the specified switch
undo info-center switch-on { unit-id |
master | all } [ debugging | logging |
trapping ]*
You can turn on/off the synchronization switch of the specified information on the
specified switch as needed.
To Next Page
Loading...
Need help?
General
