Huawei Quidway S3500 Series User Manual

Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration
Huawei Technologies Proprietary
2-12
z Enable/Disable cluster function
z Enter cluster view
z Configure cluster IP address pool
z Name the administrator device and cluster.
z Add/delete a cluster member device
z Setup a cluster automatically.
z Member accessing
z Set cluster holdtime.
z Set cluster timer to specify the handshaking message interval.
z Configure FTP/TFTP Servers and Logging/SNMP Hosts for a Cluster.
 Note:
You need to enable the cluster function and configure cluster parameters on an
administrator device. However, you only have to enable the cluster function on the
member devices and Candidate devices.
2.4.2 Enable/Disable Cluster Function
Enable the cluster function before using it.
Perform the following configuration in system view.
Table 2-13 Enable/Disable cluster function
Operation Command
Enable cluster function.
cluster enable
Disable cluster function.
undo cluster enable
Above commands can be used on any device supporting the cluster function. When
you use the undo cluster enable command on an administrator device, the system will
delete the cluster and disable the cluster function on it. When you use it on a member
device, the system will exit the cluster and disable the cluster function on it.
By default, the cluster function is enabled.
2.4.3 Enter cluster view
You must enter cluster view before configure the cluster function.
Perform the following configuration in system view.

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English