Huawei Quidway S3500 Series User Manual

Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 1 File System Management
Huawei Technologies Proprietary
1-12
Table 1-14 Configuration of the switch as TFTP client
Device Configuration Default Description
Configure IP address for
the VLAN interface of
the switch, in the same
network segment as that
of TFTP server.
--
TFTP is right for the case where no
complicated interactions are
required between the client and
server. Make sure that the IP
address of the VLAN interface on
the switch is in the same network
segment as that of the TFTP
server.
Switch
Use the tftp command to
log into the remote TFTP
server for file uploading
and downloading.
- -
PC
Start TFTP server and
set authorized TFTP
directory.
- --
1.4.2 Configure the File Transmission Mode
TFTP transmits files in two modes, binary mode for program files and ASCII mode for
text files. You can use the following commands to configure the file transmission mode.
Perform the following configuration in system view.
Table 1-15 Configure the file transmission mode
Operation Command
Configure the file transmission mode tftp { ascii | binary }
By default, TFTP transmits files in binary mode.
1.4.3 Download Files by means of TFTP
To download a file, the client sends a request to the TFTP server and then receives
data from it and sends acknowledgement to it. You can use the following commands to
download files by means of TFTP.
Perform the following configuration in system view.
Table 1-16 Download files by means of TFTP
Operation Command
Download files by means of TFTP
tftp get //A.A.A.A/xxx.yyy mmm.nnn

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English