Operation Manual - Reliability
Quidway S3500 Series Ethernet Switches Chapter 1 VRRP Configuration
Huawei Technologies Proprietary
1-8
By default, value-reduced is taken 10.
 Note:
When the switch is an IP address owner, its interfaces cannot be tracked.
1.3 Display and Debug VRRP
After the above configuration, execute display command in any view to display the
running of the VRRP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug VRRP configuration.
Table 1-9 Display and debug VRRP
Operation Command
Display VRRP state information.
display vrrp [ interface vlan-interface
interface-num ] [ virtual-router-ID ]
Enable VRRP debugging. debugging vrrp { state | packet }
Disable VRRP debugging. undo debugging vrrp { state | packet }
You can enable VRRP debugging to display how it runs. You can set the argument
option to packet or state to debug the VRRP packet or VRRP state respectively. By
default, the switch disables the debugging.
1.4 VRRP Configuration Example
1.4.1 VRRP Single Virtual Router Example
I. Networking requirements
Host A uses the VRRP virtual router which combines switch A and switch B as its
default gateway to visit host B on the Internet.
VRRP virtual router information includes: virtual router ID1, virtual IP address
202.38.160.111, switch A as the Master and switch B as the BACKUP allowed
preemption.
To Next Page
Loading...
Need help?
General
