Operation Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration
Huawei Technologies Proprietary
2-16
Note that the above command can only be executed on the administrator device, which
will advertise the cluster timer value to the member devices.
By default, handshaking message is transmitted every 10 seconds.
2.4.10 Configure Remote Control over the Member device
The communication between the administrator device and member devices may be
interrupted due to some configuration errors. If the member device cannot be controlled
in regular way, you can use remote control function provided by administrator device to
control member device remotely. For example, you can delete the booting configuration
file and reset the member device.
Normally, the cluster packets can only be forwarded over VLAN1. In case of
configuration error, for example, the member port connected to the administrator
device is configured to VLAN2, the member device and the administrator device will not
be able to communicate with each other. However, you can configure VLAN check on
the administrator device to solve this problem. After this task is conducted, the
configuration information will be contained in the cluster packets. The member device
will automatically add the port receiving such packets to VLAN1, if the port does not
belong to it. Thus the normal communication between an administrator device and
member device is ensured.
You can use the following command to perform the configuration.
Perform the following configuration in cluster view.
Table 2-21 Configure remote control over the member device
Operation Command
Reset member device
reboot member { member-num |
mac-address H-H-H } [ eraseflash ]
Configure to perform VLAN check for
communication inside the cluster.
port-tagged vlan vlanid
Configure not to perform VLAN check
for communication inside the cluster.
undo port-tagged
Note that the above command can only be executed on the administrator device.
When using the reboot member command, you can decide to delete the configuration
file or not with the eraseflash parameter.
2.4.11 Configure the Cluster Server and Network Management and Log
Hosts
After a cluster is set up, you can configure the server and network management and log
hosts on the administrator device for the entire cluster.
To Next Page
Loading...
Need help?
General
