EasyManuals Logo

Huawei Quidway S3500 Series User Manual

Huawei Quidway S3500 Series
671 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #543 background imageLoading...
Page #543 background image
Operation Manual - Reliability
Quidway S3500 Series Ethernet Switches Chapter 1 VRRP Configuration
Huawei Technologies Proprietary
1-5
Table 1-4 Configure the priority of switches in the virtual router.
Operation Command
Configure the priority of switches in the
virtual router.
vrrp vrid virtual-router-ID priority
priority
Clear the priority of switches in the virtual
router.
undo vrrp vrid virtual-router-ID
priority
By default, the priority is 100.
 Note:
The priority for IP address owner is always 255, which cannot be configured otherwise.
1.2.5 Configure Preemption and Delay for a Switch within a Virtual Router
Once a switch in the virtual router becomes the Master switch, so long as it still
functions properly, other switches, even configured with a higher priority later, cannot
become the Master switch unless they are configured to work in preemption mode. The
switch in preemption mode will become the Master switch, when it finds its own priority
is higher than that of the current Master switch. Accordingly, the former Master switch
will become the BACKUP switch. Together with preemption settings, a delay can also
be set. In this way, a Backup will wait for a period of time before becoming a Master. In
an unstable network if the BACKUP switch has not received the packets from the
Master switch punctually, it will become the Master switch. However, the failure of
BACKUP to receive the packets may be due to network congestion, instead of the
malfunction of the Master switch. In this case, the Backup will receive the packet after a
while. The delay settings can thereby avoid the frequent status changing.
Perform the following configuration in VLAN interface view.
Table 1-5 Configure preemption and delay for a switch within a virtual router
Operation Command
Enable the preemption mode and
configure a period of delay.
vrrp vrid virtual-router-ID preempt-mode
[ timer delay delay-value ]
Disable the preemption mode.
undo vrrp vrid virtual-router-ID
preempt-mode
The delay ranges from 0 to 255, measured in seconds. By default, the preemption
mode is preemption with a delay of 0 second..

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S3500 Series and is the answer not in the manual?

Huawei Quidway S3500 Series Specifications

General IconGeneral
BrandHuawei
ModelQuidway S3500 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals