Operation Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 2 Portal Configuration
Huawei Technologies Proprietary
2-5
The Portal servers are installed and configured. For the installation and configuration,
refer to Comprehensive Access Management Server Portal User Manual.
Note:
z For DHCP configurations, refer to Quidway S3500 Series Ethernet Switches
Operation Manual.
z For the AAA and RADIUS configurations, refer to the following chapter.
2.2.2 Portal Configuration Tasks
The following table describes Portal configuration tasks.
Table 2-1 Port configurations
Steps Command Description
Enter the system view
system-view
—
Configure Portal servers
portal server
server-name { ip
ip-address | key
key-string | port port |
url url-string } *
Required. By default, no
Portal server is configured.
When a Portal server is
configured, by default,
key-string is Huawei, port is
50,100, and url-string is an IP
address character string.
Configure Portal
operating modes
portal method { direct
| redhcp | layer3 }
Optional. By default, Portal
operating mode is direct
authentication.
Configure authentication
network segments
portal auth-network
network-address
net-mask vlan vlan_id
When configuring Portal
operating mode as Layer 3
Portal authentication, you
must configure this
command. When others are
configured for the Portal
operating mode, you do not
need to configure this
command.
Time intervals for ARP
handshaking with user
PCs and the maximum
number of times for
handshake to fail
portal arp-handshake
{ interval interval |
retry-times
retry-times }*
Optional. This task is only
valid for direct authentication
and re-DHCP authentication.
By default, the time interval
for ARP handshake is 60
seconds, and the maximum
number of times for
handshake to fail is 5.
Enter the VLAN interface
view
interface
vlan-interface vlan_id
—
To Next Page
Loading...
