Huawei Quidway S3500 Series User Manual

Operation Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 1 MSTP Region-configuration
Huawei Technologies Proprietary
1-26
When configure a port, only one configuration can be effective among loop protection,
Root protection and Edge port configuration at same moment.
By default, the switch does not enable BPDU protection or Root protection.
For more about the configuration commands, refer to the Command Manual.
1.2.15 Enable MSTP on the Device
You can use the following command to enable MSTP on the device.
Perform the following configuration in system view.
Table 1-23 Enable/Disable MSTP on a device
Operation Command
Enable MSTP on a device.
stp enable
Disable MSTP on a device.
stp disable
Restore the disable state of MSTP, as defaulted.
undo stp
Only if MSTP has been enabled on the device will other MSTP configurations take
effect.
By default, MSTP is disabled.
1.2.16 Enable/Disable MSTP on a Port
You can use the following command to enable/disable MSTP on a port. You may
disable MSTP on some Ethernet ports of a switch to spare them from spanning tree
calculation. This is a measure to flexibly control MSTP operation and save the CPU
resources of the switch.
MSTP can be enabled/disabled on a port through the following ways.
I. Configure in system view
Perform the following configuration in system view.
Table 1-24 Enable/Disable MSTP on a port
Operation Command
Enable MSTP on a port.
stp interface interface-list enable
Disable MSTP on a port.
stp interface interface-list disable
Restore the default MSTP state on the port.
undo stp interface-list

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English