Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-27
By default, the log, debugging and trap information synchronization switch of master in
Fabric are all turned on. The log, debugging and trap information synchronization
switch of other switches are turned on.
4.5.10 Displaying and Debugging Info-center
After the above configuration, performing the display command in any view, you can
view the running state of the info-center. You also can authenticate the effect of the
configuration by viewing displayed information. Performing the reset command in user
view, you can clear statistics of info-center.
Perform the following operation in user view. The display command still can be
performed in any view.
Table 4-48 Displaying and debugging info-center
Operation Command
Display the content of information channel
display channel [ channel-number
| channel-name ]
Display configuration of system log and
memory buffer
display info-center
Clear information in memory buffer
reset logbuffer
Clear information in trap buffer
reset trapbuffer
4.5.11 Configuration examples of sending log to Unix loghost
I. Networking Requirement
The networking requirement are as follows:
z Sending the log information of the switch to Unix loghost
z The IP address of the loghost is 202.38.1.10
z The information with the severity level above informational will be sent to the
loghost
z The output language is English
z The modules that allowed to output information are ARP and IP
To Next Page
Loading...
Need help?
General
