Huawei Quidway S3500 Series User Manual

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-4
z Configuring BGP-advertised network routes
z Configuring interaction between BGP and IGP
z Configuring BGP route aggregation
z Configuring BGP route filtering
z Configuring BGP route dampening
4) BGP protocol configuration
z Configuring BGP preference
z Configuring BGP timer
z Configuring local precedence
z Configuring MED value of AS
5) BGP application configuration
z Comparing MED values from different AS neighbors
6) BGP networking configuration
z Configuring BGP Route Reflector
z Configuring AS confederation attributes
7) Others
z Resetting BGP connection
z Refreshing BGP routes
5.2.1 Enabling BGP
To enable BGP, local AS number should be specified. After the enabling of BGP, local
router listens to BGP connection requests sent by adjacent routers. To make the local
router send BGP connection requests to adjacent routers, refer to the configuration of
the peer command. When BGP is disabled, all established BGP connections will be
disconnected.
Perform the following configurations in system view.
Table 5-1 Enabling/Disabling BGP
Operation Command
Enable BGP and enter the BGP view
bgp as-number
Disable BGP undo bgp [ as-number ]
By default, BGP is not enabled.
5.2.2 Configuring basic features for BGP peer
BGP speakers exchanging BGP packets compose BGP peers. To configure multiple
peers to use same route update policy, users may distribute them to a BGP peer group
to facilitate the configuration.
In the case of any change in the configuration of the group, configuration of each group
member changes accordingly. Users may, however, configure certain attributes for

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English