Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-22
III. Configuring the autonomous system confederation nonstandard
If it is necessary to perform the interconnection with the devices whose implementation
mechanism is different from that of RFC1965, you must configure all the routers in the
confederation.
Perform the following configurations in BGP view.
Table 5-37 Configuring AS confederation attribute compatible with nonstandard
Operation Command
Configure AS confederation attribute compatible
with nonstandard router
confederation nonstandard
Cancel AS confederation attribute compatible
with nonstandard router
undo confederation
nonstandard
By default, the configured confederation is consistent with RFC1965.
5.2.17 Defining ACL, AS Path List, and Route-policy
This section describes the configuration of ACL, AS path list, and Route-policy.
I. Defining the ACL
Refer to “Define ACL” in QoS/ACL Operation Manual and Command Manual.
II. Defining the AS path list
The routing information packet of the BGP includes an autonomous system path
domain. The as path-list can be used to match with the autonomous system path
domain of the BGP routing information so as to filter the routing information, which does
not conform to the requirements. For the same list number, the user can define multiple
pieces of as path-list, i.e. a list number stands for a group of as path ACLs. Each AS
path list is identified with digit.
Please perform the following configurations in the system view:
Table 5-38 Defining the AS path list
Operation Command
Define the AS path list
ip as-path-acl acl-number { permit | deny }
as-regular-expression
Delete the specified AS list
undo ip as-path-acl acl-number
By default, no AS path list is defined.
During the matching, the relationship of “OR” is available between the members
(acl-number) of the ACLs, i.e., when the routing information passes through one piece
To Next Page
Loading...
Need help?
General
