Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 4 OSPF Configuration
Huawei Technologies Proprietary
4-28
[Switch A-ospf-area-0.0.0.0] network 196.1.1.0 0.0.0.255
# Configure Switch B:
[Switch B] interface vlan-interface 7
[Switch B-Vlan-interface7] ip address 196.1.1.2 255.255.255.0
[Switch B] interface vlan-interface 8
[Switch B-Vlan-interface8] ip address 197.1.1.2 255.255.255.0
[Switch B] router id 2.2.2.2
[Switch B] ospf
[Switch B-ospf] area 0
[Switch B-ospf-area-0.0.0.0] network 196.1.1.0 0.0.0.255
[Switch B-ospf-area-0.0.0.0] quit
[Switch B-ospf] area 1
[Switch B-ospf-area-0.0.0.1] network 197.1.1.0 0.0.0.255
[Switch B-ospf-area-0.0.0.1] vlink-peer 3.3.3.3
# Configure Switch C:
[Switch C] interface Vlan-interface 1
[Switch C-Vlan-interface1] ip address 152.1.1.1 255.255.255.0
[Switch C] interface Vlan-interface 2
[Switch C-Vlan-interface2] ip address 197.1.1.1 255.255.255.0
[Switch C] router id 3.3.3.3
[Switch C] ospf
[Switch C-ospf] area 1
[Switch C-ospf-area-0.0.0.1] network 197.1.1.0 0.0.0.255
[Switch C-ospf-area-0.0.0.1] vlink-peer 2.2.2.2
[Switch C-ospf-area-0.0.0.1] quit
[Switch C-ospf] area 2
[Switch C-ospf-area-0.0.0.2] network 152.1.1.0 0.0.0.255
4.5 OSPF Fault Diagnosis and Troubleshooting
Fault 1: OSPF has been configured in accordance with the above-mentioned steps, but
OSPF on the router cannot run normally.
Troubleshooting: Please check according to the following procedure.
Troubleshooting locally: Check whether the protocol between two directly connected
routers is in normal operation. The normal sign is the peer state machine between the
two routers reaches the FULL state. (Note: On a broadcast or NBMA network, if the
To Next Page
Loading...
Need help?
General
