Huawei Quidway S3500 Series - Page 246

Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-28
[Switch B-Vlan-interface2] ip address 192.1.1.2 255.255.255.0
# Configure VLAN 3:
[Switch B] interface Vlan-interface 3
[Switch B-Vlan-interface3] ip address 193.1.1.2 255.255.255.0
# Configure peers.
[Switch B] bgp 200
[Switch B-bgp] peer 192.1.1.1 as-number 100
[Switch B-bgp] peer 193.1.1.1 as-number 200
3) Configure Switch C:
# Configure VLAN 3:
[Switch C] interface Vlan-interface 3
[Switch C-Vlan-interface3] ip address 193.1.1.1 255.255.255.0
# Configure VLAN 4:
[Switch C] interface vlan-Interface 4
[Switch C-Vlan-interface4] ip address 194.1.1.1 255.255.255.0
# Configure BGP peers and route reflector.
[Switch C] bgp 200
[Switch C-bgp] peer 193.1.1.2 as-number 200
[Switch C-bgp] peer 193.1.1.2 reflect-client
[Switch C-bgp] peer 194.1.1.2 as-number 200
[Switch C-bgp] peer 194.1.1.2 reflect-client
4) Configure Switch D:
# Configure VLAN 4:
[Switch D] interface vlan-interface 4
[Switch D-Vlan-interface4] ip address 194.1.1.2 255.255.255.0
# Configure BGP peers
[Switch D] bgp 200
[Switch D-bgp] peer 194.1.1.1 as-number 200
Using display bgp routing-table command, you can view BGP routing table on Switch
B. Note: Switch B has known the existence of network 1.0.0.0.
Using display bgp routing-table command ,you can view the BGP routing table on
Switch D. Note: Switch D also knows the existence of network 1.0.0.0.