Operation Manual - Getting Started
Quidway S3500 Series Ethernet Switches Chapter 4 User Interface Configuration
Huawei Technologies Proprietary
4-8
Note:
By default, the password is required for authenticating the Modem and Telnet users
when they log in. If the password has not been set, when a user logs in, he will see the
prompt “Login password has not been set !”.
If the authentication-mode none command is used, the Modem and Telnet users will
not be required to input password.
II. Setting the command level used after a user logging in
The following command is used for setting the command level used after a user logging
in.
Perform the following configuration in local-user view.
Table 4-15 Setting the command level used after a user logging in
Operation Command
Set a service type for the specified user (For
S3552 series, S3528 series, S3526E series
and S3526C)
service-type { ftp [ ftp-directory
directory ] | lan-access | { ssh |
telnet }* [ level level ] }
Cancel the service type of the specified user
(For S3552 series, S3528 series, S3526E
series and S3526C)
undo service-type { ftp
[ ftp-directory ] | lan-access | { ssh
| telnet }* [ level level ] }
Set a service type for the specified user (For
S3526, S3526 FM and S3526 FS)
service-type { ftp [ ftp-directory
directory ] | lan-access | telnet
[ level level ] }
Cancel the service type of the specified user
(For S3526, S3526 FM and S3526 FS)
undo service-type { ftp
[ ftp-directory ] | lan-access | telnet
[ level level ] }
By default, the specified logon user can access the commands at Level 1.
III. Setting the command level used after a user logs in from a user interface
You can use the following command to set the command level after a user logs in from
a specific user interface, so that a user is able to execute the commands at such
command level.
Perform the following configuration in user interface view.
To Next Page
Loading...
Need help?
General
