Huawei Quidway S3500 Series - Page 465

Operation Manual - STP
Quidway S3500 Series Ethernet Switches Chapter 3 Digest Snooping
Huawei Technologies Proprietary
3-2
Operation Command Remark
Enable digest
snooping on the
interface
stp
config-digest-snooping
Required. Digest snooping is
disabled by default
Quit Ethernet
interface view
quit —
Enable digest
snooping globally
stp
config-digest-snooping
Required. Digest snooping is
disabled by default
Display current
configuration
information
display
current-configuration
This command can be
executed in any view
 Note:
z You must enable digest snooping on an interface first before enabling it globally.
z Digest snooping is unnecessay if the interconnected switches are from the same
vendor.
z To enable digest snooping, the interconneted switches must be configured with the
same settings.
z To enable digest snooping, all interfaces in a MSTP domain used to connect other
switches must have digest snooping enabled.
z Do not enable digest snooping on border interfaces of an MSTP domain.
z To change domain configuration, be sure to disable digest snooping first to prevent
broadcast storm.