Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Table of Contents
Huawei Technologies Proprietary
ii
3.2 Device Management Configuration ................................................................................... 3-1
3.2.1 Reboot Ethernet Switch .......................................................................................... 3-1
3.2.2 Designate the APP Adopted When Booting the Ethernet Switch Next Time.......... 3-1
3.2.3 Upgrade BootROM.................................................................................................. 3-2
3.2.4 Set Temperature Limit............................................................................................. 3-2
3.3 Display and Debug Device Management Configuration.................................................... 3-2
Chapter 4 System Maintenance and Debugging........................................................................ 4-1
4.1 Basic System Configuration............................................................................................... 4-1
4.1.1 Set Name for Switch ............................................................................................... 4-1
4.1.2 Set the System Clock.............................................................................................. 4-1
4.1.3 Set the Time Zone................................................................................................... 4-1
4.1.4 Set the Summer Time ............................................................................................. 4-2
4.2 Display the State and Information of the System............................................................... 4-2
4.3 System Debugging ............................................................................................................4-3
4.3.1 Enable/Disable the Terminal Debugging ................................................................ 4-3
4.3.2 Display Diagnostic Information................................................................................ 4-4
4.4 Testing Tools for Network Connection ............................................................................... 4-4
4.5 Logging Function ............................................................................................................... 4-5
4.5.1 Introduction to Info-center ....................................................................................... 4-5
4.5.2 Info-center Configuration......................................................................................... 4-8
4.5.3 Sending the Configuration Information to Loghost................................................ 4-12
4.5.4 Sending the Configuration Information to Console terminal ................................. 4-15
4.5.5 Sending the Configuration Information to Telnet Terminal or Dumb Terminal ..... 4-17
4.5.6 Sending the Configuration Information to Log Buffer............................................ 4-20
4.5.7 Sending the Configuration Information to Trap Buffer .......................................... 4-22
4.5.8 Sending the Configuration Information to SNMP Network Management.............. 4-24
4.5.9 Turn on/off the Information Synchronization Switch in Fabric .............................. 4-26
4.5.10 Displaying and Debugging Info-center................................................................ 4-27
4.5.11 Configuration examples of sending log to Unix loghost...................................... 4-27
4.5.12 Configuration examples of sending log to Linux loghost .................................... 4-29
4.5.13 Configuration examples of sending log to console terminal ............................... 4-31
Chapter 5 SNMP Configuration....................................................................................................5-1
5.1 SNMP Overview................................................................................................................. 5-1
5.2 SNMP Versions and Supported MIB.................................................................................. 5-1
5.3 Configure SNMP................................................................................................................ 5-3
5.3.1 Set Community Name............................................................................................. 5-3
5.3.2 Set the Method of Identifying and Contacting the Administrator............................. 5-3
5.3.3 Enable/Disable SNMP Agent to Send Trap ............................................................ 5-4
5.3.4 Set the Destination Address of Trap....................................................................... 5-4
5.3.5 Set Lifetime of Trap Message ................................................................................. 5-5
5.3.6 Set SysLocation ...................................................................................................... 5-5
5.3.7 Set SNMP Version .................................................................................................. 5-5
To Next Page
Loading...
