Operation Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 2 Link Aggregation Configuration
Huawei Technologies Proprietary
2-4
z If correct, configure the link aggregation again.
II. For S3526E/S3526C/S3552G/S3552P/S3528G/S3528P/S3552F Ethernet
Switches, take the following steps
z Check the input parameter and see whether the starting number of Ethernet port is
smaller than the end number. If yes, take the next step.
z Check whether the Ethernet ports that are in the configured range belong to any
other existing link aggregations. If not, take the next step.
z Check whether the ports to be aggregated operate in the same speed and full
duplex mode. If yes, take the next step.
z Check if there are no more than eight ports in one group.
z If correct, configure the link aggregation again.
To Next Page
Loading...
