Huawei Quidway S3500 Series User Manual

Operation Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 1 VLAN Configuration
Huawei Technologies Proprietary
1-5
Table 1-8 Shut down/Enable VLAN interface
Operation Command
Shut down the VLAN interface
shutdown
Enabling the VLAN interface
undo shutdown
The operation of shutting down or enabling the VLAN interface has no effect on the
UP/DOWN status of the Ethernet ports on the local VLAN.
By default, when all the Ethernet ports belonging to a VLAN are in DOWN status, this
VLAN interface is also DOWN, i.e. this VLAN interface is shut down. When there is one
or more Ethernet ports in UP status, this VLAN interface is also UP, i.e. this VLAN
interface is enabled.
1.3 Protocol-Based VLAN Configuration
 Note:
Currently, only Quidway S3552G/S3552P/S3528G/S3528P/S3552F Ethernet
Switches support the protocol-based VLAN configuration.
Protocol-based VLAN configuration includes:
z Create/Delete a VLAN protocol type
z Create/Delete the association between an port and a protocol-based VLAN
1.3.1 Create/Delete a VLAN Protocol Type
You can use the following command to create/delete a VLAN protocol type.
Perform the following configuration in VLAN view.
Table 1-9 Create/delete a VLAN protocol type
Operation Command
Create a VLAN
protocol type
protocol-vlan [ procotol-index ] { at | ip [ ip_address
[ net_mask ] ] | ipx { ethernetii | llc | raw | snap } | mode
{ ethernetii [ etype etype_id ] | llc [ dsap dsap_id [ ssap
ssap_id ] | ssap ssap_id ] | snap [ etype etype_id ] } }
Delete an existing
VLAN protocol type
undo protocol-vlan { protocol_index [ to protocol_end ] |
all }

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English