I/O Manager ASIC information Version 2.0, Foundry IBM, Part number 0
I/O Manager ASIC information Version 2.0, Foundry IBM, Part number 0
Start time: 2002-03-19 13:13:26 PST
Uptime: 6 days, 1 hour, 19 minutes, 36 seconds
Meaning The command output shows status information for the FPC in slot 3, including the
operating state. The state can be online, dead, diag, dormant, empty, online, probed, or
probe-wait. If the FPC state is dead, an alarm occurs. For more detailed information about
the FPC states, see the Junos OS Routing Protocols Configuration Guide, Class of Service
Configuration Guide, and Junos OS System Basics and Services Command Reference. The
command output also shows temperature, memory usage, I/O Manager
application-specific integrated circuit (ASIC) version level, start time, and uptime. The
uptime is important to determine how long the FPC has been operational. A small uptime
means that the FPC came online a short time ago and could indicate a possible FPC error
condition.
show
chassis
fpc
<pic-status
<
fpc-slot >>show chassis fpc <detail < fpc-slot >>
Checking FPC Status and Temperature
Purpose (M40e, M160, M320, T320, and T640 router only) To verify FPC error conditions by
checking the FPC status and temperature for a particular FPC slot.
Action To display the FPC status and temperature for a particular FPC slot, use the following
command:
user@host> show chassis environment fpc fpc-slot
user@m160> show chassis environment fpc 0
FPC 0 status:
State Online
Temperature 39 degrees C / 102 degrees F
Power:
1.5 V 1496 mV
2.5 V 2485 mV
3.3 V 3306 mV
5.0 V 4991 mV
5.0 V bias 4993 mV
8.0 V bias 8251 mV
CMB Revision 12
Meaning The command output displays the status of the FPC in slot 0, including the state,
temperature, voltage levels on the FPC, and the revision level of the chassis management
bus backup. The state can be Unknown, Empty, Present, Ready, Announce online, Online,
Offline, or Diagnostics. An Offline state indicates an FPC error condition.
Checking FPC Status and Temperature in a T1600 Router
Purpose To verify FPC error conditions by checking the FPC status and temperature for a particular
FPC slot in a T1600 router.
Copyright © 2012, Juniper Networks, Inc.218
M Series and T Series Routers Monitoring and Troubleshooting Guide
To Next Page
Loading...
Need help?
General
