Juniper M Series User Manual

Related
Documentation
Checklist for Monitoring the SCG on page 401•
Monitor the SCG Status
To monitor the SCG status:
1.
Monitor the SCG Environmental Status on page 404
2.
Display the SCG LED States at the Command Line on page 405
3.
Check the SCG LEDs States on the Faceplate on page 405
Monitor the SCG Environmental Status
Purpose To obtain information about the SCG environmental status.
Action To monitor the SCG environment status, use the following command:
user@host> show chassis environment
Sample Output
t320@host> show chassis environment
Class Item Status Measurement
Power PEM 0 Absent
PEM 1 OK
Temp SCG 0 OK 30 degrees C / 86 degrees F
SCG 1 OK 29 degrees C / 84 degrees F
[...Output truncated...]
Meaning The command output displays the status and temperature for each SCG.
If there is a problem with the SCG status, you can display more detailed SCG
environmental information with the following command:
user@host> show chassis environment scg
The command output is as follows:
t320@host> show chassis environment scg
SCG 0 status:
State Online - Master clock
Temperature 30 degrees C / 86 degrees F
Power:
GROUND 0 mV
3.3 V 3317 mV
5.0 V 5072 mV
5.6 V 5697 mV
1.8 V bias 1794 mV
3.3 V bias 3304 mV
5.0 V bias 4991 mV
8.0 V bias 7318 mV
BUS Revision 40
SCG 1 status:
State Online - Standby
Temperature 29 degrees C / 84 degrees F
Power:
GROUND 0 mV
Copyright © 2012, Juniper Networks, Inc.404
M Series and T Series Routers Monitoring and Troubleshooting Guide

Juniper M Series Specifications

General

Brand	Juniper
Model	M Series
Category	Network Router
Language	English