Figure 133: M120 Router DC Power Supply
Related
Documentation
Checklist for Monitoring Power Supplies on page 273•
M160 Router Power Supplies
The M160 router uses DC power. Two load-sharing, pass-through power supplies are
located at the bottom rear of the chassis. Figure 134 on page 285 shows the M160 router
power supplies and where they are installed in the chassis.
When the power supplies are installed and operational, they automatically share the
electrical load. If a power supply stops functioning for any reason, the remaining power
supplies instantly begin providing all the power the router needs for normal functioning,
and can provide full power indefinitely.
Copyright © 2012, Juniper Networks, Inc.284
M Series and T Series Routers Monitoring and Troubleshooting Guide
To Next Page
Loading...
