State Online
PIC version 1.1
Uptime 7 days, 13 hours, 29 minutes, 51 seconds
PIC Port Information:
Port Cable SFP SFP Vendor
Number Type Vendor Name Part Number
0 OC48 SHORT REACH SumitomoElectric SCP6828-J1-ANE
1 UNKNOWN CABLE
2 UNKNOWN CABLE
3 UNKNOWN CABLE
To check the PIC media type and status for a particular FPC, use the show chassis fpc
pic-status fpc-slot command.
To display PIC hardware information, including the media type description, use the show
chassis hardware command.
show
chassis
fpc
<pic-status
<
fpc-slot >>
show chassis hardware
Display the PIC Interface Status Information
Purpose To display the status information of each configured PIC interfaces.
Action To display the status of each configured interface, use the following operational mode
command:
user@host>show interfaces terse
Sample Output
user@host> show interfaces terse
Interface Adman Link Port Local Remote
so-0/0/0 up up
so-0/0/0.0 up up inet 192.168.36.201 --> 192.168.36.200
so-0/1/0 up down
so-0/1/1 up down
e1-0/2/0 up down
e1-0/2/1 up down
t1-1/0/0:1 up down
t1-1/0/0:2 up down
gr-2/0/0 up up
ip-2/0/0 up up
[...Output truncated...]
Meaning The command output shows the names of all interfaces configured on the router. The
interface name indicates the media type-fpc/pic/port (for example, so-0/0/0.0). It shows
whether the interface is on (up) or off (down) and whether the link state is up or down.
Additionally, the output shows the protocol configured on that interface and the local
address of the interface, as well as the address of the remote side of a connection for
point-to-point interfaces. Refer to the PIC for port numbering.
A line in the sample output shows the status of a SONET interface on FPC 0, PIC 0, port
0, and logical unit number 0. The status of the interface is up. The link status is up. The
Copyright © 2012, Juniper Networks, Inc.240
M Series and T Series Routers Monitoring and Troubleshooting Guide
To Next Page
Loading...
Need help?
General
