Juniper M Series - Page 346

Table 86: Power Supply Alarms (continued)
CLI Long Version
Craft Interface LCD
Short VersionPower Supplies
Power supply x not providing powerSupply x FAILM40
Power supply x 3.3V failedSupply x 3V FAIL
Power supply x 5V failedSupply x 5V FAIL
Power supply x 2.5V failedSupply x 2V FAIL
YELLOW ALARM - PEM pem-ID RemovedPEM pem-ID RemovedM40e
RED ALARM - PEM pem-ID High
Temperature
PEM pem-ID High Temp
RED ALARM - PEM pem-ID Output FailurePEM pem-ID Output Fail
RED ALARM - PEM pem-ID Input FailurePEM pem-ID Input Fail
YELLOW ALARM - PEM pem-number
Removed
N/AM120
RED ALARM - PEM pem-number High
Temperature
N/A
RED ALARM - PEM pem-number Output
Failure
N/A
RED ALARM - PEM pem-number Input
Failure
N/A
YELLOW ALARM - PEM pem-number
Removed
PEM pem-number RemovedM160
RED ALARM - PEM pem-number High
Temperature
PEM pem-number High Temp
RED ALARM - PEM pem-number Output
Failure
PEM pem-number Output Fail
RED ALARM - PEM pem-number Input
Failure
PEM pem-number Input Fail
Copyright © 2012, Juniper Networks, Inc.302
M Series and T Series Routers Monitoring and Troubleshooting Guide