172 Chapter 9: Basic Operation
XL8 Control Centre
Operator Manual
To select an input channel via the GUI
You can select an input channel within a bank using glide pad and GUI. When the new
input channel is selected the controls that were last used, that is, preamp, EQ, DYN or
mixes, are displayed in the GUI channel strip.
1 Move GUI’s cursor to within the input channel you wish to select, but make sure it is
not over a control, such as a button, control knob, fader etc.
2 Click button to select input channel.
Note:
On the glide pad, you can also carry out
selection by using a single tap on the pad
itself.
1
2
GUI channel
strip
To Next Page
Loading...
