200 Chapter 10: Advanced Operation
XL8 Control Centre
Operator Manual
To set up a stereo aux
The procedure is similar to that detailed in “To set up a mono aux mix” on page 185.
However, the pair of auxes must first be linked. Do this by selecting the odd numbered
channel of the pair to the mix bay (the stereo LINK button does not appear on even
numbered channels). Then, with mix LED highlighted, click on the stereo LINK switch
to change the bus to stereo from mono; as indicated by the stereo LINK switch being
illuminated.
To set up a group (subgroup)
Referring to the procedure detailed in “To set up a mono aux mix” on page 185, select
the group bus mode using the MODE button.
To set up a mix minus
Referring to the procedure detailed in “To set up a mono aux mix” on page 185, select
the mix minus bus mode using the MODE button.
To Next Page
Loading...
