237
XL8 Control Centre
Operator Manual
Chapter 12:Automation
Refer to “Automation” on page 117 and “Scenes (automation)” on page 191.
The control centre’s automation system can store and recall up to 1000 scenes, each
one being a snapshot of the control console’s settings at the instant the scene was
created. By recalling scenes, users can restore the control centre to the exact state
that existed at that time. This makes it ideal for multi-act tours by providing quick and
accurate access of settings for the band with a minimum of sound check time, as well as
for theatre productions, where each act requires reconfiguration of audio I/O.
Automation control
Although the automation section is supported on the output bay control surface by
illuminated switches and jogwheel, it also requires large amounts of screen support.
The control is broadly divided into two sections: scene store/recall and system (edit).
The store/recall section is intended for fast operation during show time and rehearsals,
and is mostly supported by front panel hard switches etc. System edit is comprised
mainly of the scope and MIDI buttons down the left-hand side of the GUI screen (see
page 238).
To Next Page
Loading...
