Oki IP-6620 - Page 272

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-113
No
Items to be Checked
Action
2
Wiper position sensor’s condition
Check that the sensor is fixed securely.
3
Harness condition
Check that the harness condition is proper as follows.
- The connectors are connected securely.
- The cable is not disconnected.
- The harness is not pinched by other parts.
- The cable jacket is not damaged.
4
Wiper position sensor
If the error persists when the wiper operates, replace the
sensor.
5
Wiping motor
Replace the motor.
6
PCB-ASSY-ACT3
Replace the PCB-ASSY-ACT3.